When performing a fresh text-mode installation of Puppet Enterprise (PE), you can configure r10k by adding parameters to the
pe.conf file. In existing
installations, configure r10k by
adjusting parameters in the console.
Upgrading from previous versions of r10k
If you used r10k prior to PE version 2015.3, you might have configured it in the
console using the
pe_r10k class. We
suggest configuring r10k in the
master profile class, and then customizing your configuration as needed in Hiera.
This simplifies configuration, and makes it easier to move to Code Manager in the future.
To switch to master profile class configuration, remove the
pe_r10k class in the
console, and then configure r10k as described in the topic about configuring r10k after PE installation. You can then customize your
configuration in Hiera if
Note: If you were using earlier
versions of r10k with the
discontinue use of the module and switch to the master profile configuration as
Configure r10k during installation
To set up r10k during PE installation, add the r10k parameters to
starting installation. This is the easiest way to set up r10k with a new PE installation.
Ensure that you have a Puppetfile and a control repo. You'll also need the SSH private key that you created when you made your control repo.
This setting specifies the location of the control repository. It accepts a string that is a valid URL for your Git control repository.
This setting specifies the path to the file that contains the SSH private key used to access your Git repositories. This location for the SSH private key file, which you created when you set up your control repository, must be located on the Puppet master and owned by and accessible to the
pe-puppetuser. The setting accepts a string.r10k
- Complete PE installation. The installer configures r10k for you. You can change the values for the remote and the private key as needed in the master profile settings in the console.
After PE installation is complete, place the SSH private key
you created when you set up your control repository in the
- Run r10k. PE does not automatically run r10k.
Configure r10k after PE installation
To configure r10k in an existing PE, set r10k parameters in the console. You can also adjust r10k settings in the console.
In the console, set the following parameters in the
puppet_enterprise::profile::masterclass in the PE Master node group:
This is the location of your control repository. Enter a string that is a valid URL for your Git control repository, such as
This is the path to the private key that permits the
pe-puppetuser to access your Git repositories. This file must be located on the Puppet master, owned by the
pe-puppetuser, and in a directory that the
pe-puppetuser has permission to view. We recommend
/etc/puppetlabs/puppetserver/ssh/id-control_repo.rsa. Enter a string, such as
- Run Puppet on all of your masters.
You can now customize your r10k configuration in Hiera, if needed. After r10k is configured, you can deploy your environments from the command line. PE does not automatically run r10k at the end of installation.